LEGO® is a trademark of the LEGO group of companies which does not sponsor, authorize, or endorse this site.
Here are some LEGO® birds to build! This is a great building project for beginners. We’ve got designs for a couple of owls, some ducks, a cardinal, and a peacock.
The peacock is probably my favorite! Each of these birds were designed by my 10 year old, with only minor revisions by me. He’s getting good at LEGO® designs!
Peacocks are totally “in” right now, and here’s a brick version that is simple to build.
We had an 8 x 8 green square plate that we used for the base of the tail. If you don’t have that, then just attach green plates to create the tail shape.
All of the bricks used in this project can be seen in the photo, so I didn’t do full instructions for this one. The base of the body is a 2 x 4 blue plate. Then use a 1 x 2 plate with a handle on the side and two 1 x 2 plates with clips to attach the tail to the body.
The head is attached to a 1 x 2 black plate with one stud on top.
Build male and female mallard ducks. So cute! My son used a 2 x 3 yellow plate with one rounded end for the bill of the male, but we didn’t have a second one so I used a 2 x 3 plate when building the female.
Build an adorable little owl!
Step 1: Start with a 2 x 3 brown plate.
Step 2: Add a 2 x 2 inverted slope, a 1 x 2 inverted slope, and a 2 x 3 brick.
Step 3: Add two 1 x 1 bricks, a 1 x 2 slope, and two 1 x 1 slopes (30 degree).
Step 4: Add three rows of tan bricks for the belly of the owl.
Step 5: Add two 2 x 2 slopes and a 1 x 2 brick.
Step 6: Place a 2 x 3 plate on top of the bricks from step 5. Then add a 1 x 2 brick and two 2 x 2 inverted slopes.
Step 7: Build the head and eyes. Add three 1 x 1 bricks with a stud on the side, two 1 x 2 bricks, a 1 x 1 brick, and one more 1 x 2 brick. Attach eyes to two of the 1 x 1 bricks with a stud on the side.
Step 8: Attach the beak between the eyes – a light orange 1 x 1 plate with one claw. Build the top of the head with four 1 x 2 dark brown slopes and a 1 x 2 brown brick. Gather the bricks shown.
Step 9: Attach a 1 x 2 curved slope over the beak, and then add the remaining bricks to the top of the head.
Step 10: Build the sides of the body and the wings as shown.
Step 11: Attach the brown sections to each side of the body.
Step 12: Attach the feet, and add a 1 x 3 brown plate behind the feet to keep the owl balanced.
Step 13: Attach the wings to the sides of the body and the owl is complete!
Gresham used the same design to build a Snowy Owl also.
Here’s a cardinal to build – again, you can see all the pieces used. The tail is attached to a 1 x 2 plate with clips on the side, which makes it adjustable.
Have fun building!
We’re participating in LEGO® week this week – be sure to check out the rest of the LEGO® Week Activities!